Freud · Flush trim and template bits
Freud 50-509 top and bottom bearing flush trim bit
1/2 in
When to choose it
The 50-509 can follow a reference surface on either end of its straight carbide section. The two pilots have the same nominal diameter as the cutter, so this is a flush trim profile for copying an established edge.
Choose it when the 1-5/8-inch cutting height and 1/2-inch collet suit the setup. A smaller template or tight inside curve can make the 3/4-inch cutter diameter the deciding limit.
Specifications
- Brand
- Freud
- Cutting profile
- Bearing-guided trim
- Model
- 50-509
- Shank
- 1/2 in
- Cut and bearing diameter
- 3/4 in
- Carbide height
- 1-5/8 in
- Overall length
- 3-7/8 in
- Cutters
- Two
- Amazon.com reference
- B000BVB1ME
Care and other choices
Review the cutter dimensions and collet fit ↑
Related choice Freud 50-501 dual-bearing flush trim bit ↗
Compare options in this department ↗
Documentation
Questions about this product
Does it require a template on one specific side?
The two bearings give a choice of reference side when the setup allows either pilot to contact it.
Will it cut an inside corner square?
A round cutter leaves a radius at an inside turn.
How is 50-501 different?
It retains both bearings with a 1/2-inch diameter and 1/4-inch shank, so check which geometry and collet you need.
