Whiteside · Flush trim and template bits
Whiteside UDFT2100 compression flush trim spiral
1/4 in
When to choose it
The UDFT2100 combines opposing spiral directions with a pilot at the tip for template-guided flush trimming. Its quarter-inch nominal cutter width is useful when comparing the clearance of a small inside curve.
The two bearings form one tip guide. Check that your template can contact that end. If you need a choice of reference sides, compare a design with bearings on opposite ends, such as the Freud 50-501.
Specifications
- Brand
- Whiteside
- Cutting profile
- Bearing-guided trim
- Model
- UDFT2100
- Shank
- 1/4 in
- Cut diameter
- 1/4 in
- Cut length
- 1 in
- Overall length
- 3 in
- Pilot
- Double ball-bearing guide at the tip
- Amazon.com reference
- B07KQHC6CX
Care and other choices
Review the cutter dimensions and collet fit ↑
Related choice Freud 50-501 dual-bearing flush trim bit ↗
Compare options in this department ↗
Documentation
Questions about this product
Are the bearings at opposite ends?
Whiteside describes a double ball-bearing guide at the tip. Both bearings serve that same reference end.
How long is the cutting section?
It is 1 inch within a 3-inch overall length.
Can it fit a 1/2-inch collet directly?
The shank is 1/4 inch. Use a router collet that matches the bit size.
